Printable View
hai all,
I have a Pan Tilt unit which is connected to a Laptop using ethernet port. Iam using QTcpSocket to connect to this device and it is getting connected. But when I am passing commands to Pan or Tilt the camera unit it is not responding. What will be the reason for this? Anyone has done this type of socket programming. Here server is this device.
thanks in advance.
PVR
Commands are not reaching the other end, commands are invalid, you are not receiving the response correctly, the remote device does not send a response... I am not sure what you expect us to do here. We have no idea what your code is doing. Perhaps if you showed what you had tried it would be obvious.Quote:
What will be the reason for this?
Oh yes. Please stop opening new threads on the same topic. You already have this one and this and this.
hai..
My aim is to move the camera (azhimuth and elevation) which is mounted over the pan tilt unit. If I have to move the unit 20 degree azhimuth, the command should be AP2000.
When connecting with QTcpSocket it shows connected, but after that no response. No idea about the device is receiving command.
QTcpSocket *qtcp=new QTcpSocket(this);
qtcp.connectToHost("192.168.1.41",80)// device ip
if(qtcp.waitforConnected())
{
qDebug()<<"connected");
qtcp.write("AP2000\n");
}
PVR
The device requires no setup? No commands sent for configuration, no handshaking, no nothing else before it gets a command to move?Quote:
the command should be AP2000.
Since no one here has a clue about your hardware or how to use it, it might be better for you to consult the maufacturer's documentation or web site for information about how to program for this device and maybe see an example program for it.
Your question really has nothing to do with Qt other than the fact that you are using Qt sockets.
Thank u very much for the reply. The manufacturer used labview to operate this unit. But we want to control this unit from the GUI of qt.
You should be able to read the commands issued via TCP in the LabView program and follow the same sequence using TCP in a Qt program.Quote:
The manufacturer used labview to operate this unit.
The problem is not Qt, it is the commands you send to the device and the syntax they use. Surely the manufacturer has a manual for this device that explains how to control it.
But you have all of us guessing in the dark. You haven't told us anything about this device except that it is a "Pan Tilt unit". Who makes it? What model is it? What is the link to the manufacturer's web site?