If I open an example project (like elastic nodes, or fridge magnets) and run it, then it works fine.
If I rebuild it, that seems to go without errors. (looking at the compile output).

However, if I rebuild it again I get errors like;

mingw32-make: Leaving directory `D:/Qt/2009.04/qt/examples/graphicsview/elasticnodes'
Could Not Find D:\Qt\2009.04\qt\examples\graphicsview\elasticnode s\release\moc_graphwidget.cpp
Could Not Find D:\Qt\2009.04\qt\examples\graphicsview\elasticnode s\release\edge.o
Exited with code 0.
Configuration unchanged, skipping QMake step.
The errors are always of this format. (although , depending on modes, sometimes its "debug" rather then release).

It equaly applies to my own projects, and first I thought it was my code. But as its applying to the samples too, I'm now at a lose as to whats wrong.

--

ps. How would I look up "Could Not Find " on this forums search system? It assumes the "Not" to be an operator (So thus -Find). How can I escape/override that?